Now that your CAT Q10 is up and running, you can look to use some of the more advanced settings of your device should you wish. This section focuses on highlighting some (but not all) of the key features available to you.
Note: Unless you are an advanced user or have a strong requirement to change these settings, we would recommend that default settings are maintained where possible.
HOME PAGE
This is simply a dashboard that details the status of your device.
⦁ Your connection status (Connected/Not connected).
⦁ Your 5G signal strength (If available).
⦁ Your 4G LTE signal strength (If available).
⦁ Your total data uploaded and downloaded.
⦁ Number of devices connected to the Cat Q10.
⦁ Battery status.
⦁ Enables you to navigate to the device settings menu.
INTERNET
Here you can change your preferred network type or modify your connection settings.
⦁ Select your network connection type ‘5G/4G LTE/3G’.
⦁ Modify your Access Point Name (APN).
⦁ Control your SIM PIN to make your device more secure.
⦁ Enable Airplane mode (Disable network connectivity).
⦁ Enable Data Roaming.
SYSTEM
Check for updates, view details or restart the device within this setting.
⦁ View system information, e.g. IMEI, MAC and IP addresses.
⦁ Check and perform Firmware updates.
⦁ Change Admin password.
⦁ Adjust time settings.
⦁ Perform MAC filtering.
⦁ Change LAN settings.
⦁ Factory Reset Device (Restore ALL settings to factory default).
⦁ Restart Device.
CONNECTED DEVICES
⦁ Simply displays all devices currently connected to your Cat Q10.
QR CODE
⦁ Provides QR codes for other users to connect to your device.
Note: unlike the sticker inside your box, this QR code is dynamic and updates as you change your SSID and password.
BATTERY
This menu gives you the option to enable ‘Always on charge’ Mode.
We recommend you enable this feature if you plan to continuously keep your device connected to a power source. This mode limits the battery capacity to 60% and helps prevent battery damage.
Note: This mode will not degrade device performance.
OTHER
⦁ Enable/Disable USB tethering. (Default on).
⦁ This allows you to use your Q10 via USB instead of via WiFi.
⦁ Set and monitor Data usage.
⦁ Enable the feature and set a maximum data usage limit, and a reminder.
⦁ When you reach your data limit, the device will prevent further data transmission for the defined interval, unless reset.
MESSAGES
Your Cat Q10 is capable of receiving SMS notifications.
⦁ You can send basic SMS messages by clicking the ‘+’ symbol on this page.
HELP
⦁ Weblinks to support, Privacy Policy and Regulatory information.